Year
2021
Category
Oil and gas equipment
Heater with intermediate coolant PPT-0.2G designed for heating oil emulsions in oil collection and transportation systems, as well as natural or associated gas and waste field water at gas-distributing units of gas-lift oil production system, has been manufactured and shipped to the Customer.
Heaters are supplied in insulated condition of maximum factory readiness, are made according to an individual project for specific customer requirements, and are equipped with modern modular burners.
In order to operate in different modes (higher heating range — lower capacity; lower heating range — higher capacity) while maintaining acceptable values of pressure drop in the coil, heaters are equipped with specially designed flow switching unitsWould you like to discuss your project?
Our team is ready to implement a project of any complexity.
If you have assignments or questions, leave a request and we will contact you as soon as possible
Other projects
2016 year
Four sets of KDFT pipe end phase dividers designed for separation of well production and formation water treatment to the required standards were supplied.
2019 year
This is an auxiliary unit for operation of the main equipment of booster compressor station (BCS).
2019 year
The customer needed a regeneration gas heating furnace as part of the gas treatment unit.
2019 year
The Customer faced a non-standard task: oil emulsion needed to be heated directly from the well pad in the absence of prepared fuel gas to feed the heater burners and the remaining infrastructure around the well pad.