Projects Line heater unit with separation assembly BPP-1.6U

Year
2019
Category
Oil and gas equipment

The Customer faced a non-standard task: oil emulsion needed to be heated directly from the well pad in the absence of prepared fuel gas to feed the heater burners and the remaining infrastructure around the well pad.

We proposed a set of equipment, including a unit for preliminary extraction and separation of associated petroleum gas for the operation of heater burners.

The automation system of the heater unit provides:

  • automatic maintenance of the set product temperature at the outlet of the autonomous heater sections or the coolant in the tank sections by changing the fuel gas flow rate by control valves;

  • adjustment of condensate levels in the separator and gas receiver;

  • control of the following basic process parameters:

a) oil pressure at the heater inlet (for each coil);
b) fuel gas pressure after BPOG, in the receiver, after the pressure regulator, and before the burners;
c) oil temperatures at the heater inlet and outlet (for each coil);
d) fuel gas temperature in the line after BPOG, in the receiver, and after the pressure regulator;
e) temperature of the coolant in the vessel;
f) exhaust gas temperatures;
g) level of the intermediate coolant in the heater housing.

The heater automation system performs the following basic functions:

  • - automatic remote ignition of the ignition and main burners with prior ventilation of the furnace space with natural draught;
  • - manual ignition from the operator panel during the setup and testing phase;
  • - automatic maintenance of the product heating temperature by changing the fuel gas flow rate by control valves;
  • - stopping the fuel gas supply to the burners in case of emergency process parameters;
  • - emergency cause storage;
  • - stopping the fuel supply with message decoding on the operator panel and audio signal;
  • - transmission of the alarm signal to the upper level (operator's room) via a dry relay contact.

All equipment was manufactured simultaneously on two own production sites in Syzran and Yekaterinburg.

Would you like to discuss your project?

Our team is ready to implement a project of any complexity.
If you have assignments or questions, leave a request and we will contact you as soon as possible

Other projects
2018 year
Pump station of fire-fighting water supply has been commissioned.
2020 year
Capacitance water heater PVE-3.5 with heating capacity of 3.5 MW designed to heat water in the collection, transportation, and well product preparation systems is successfully operated.
2019 year
The customer needed a regeneration gas heating furnace as part of the gas treatment unit.
2021 year
Pre-commissioning works and mode adjustment of start-up and fuel gas heater PTPG-30M manufactured by Bunter Group has been carried out.
2016 year
Water heating boiler plant UKM-0.8VGZh designed for heat supply of buildings and constructions has been shipped. Boiler plant is a process complex consisting of transportable pre-fabricated module.

На этом веб-сайте используются файлы cookie, которые обеспечивают работу всех функций для наиболее эффективной навигации по странице. Если вы не хотите принимать постоянные файлы cookie, пожалуйста, выберите соответствующие настройки на своем компьютере. Продолжая навигацию по сайту, вы предоставляете свое согласие на использование файлов cookie на этом веб-сайте. Более подробная информация предоставляется в нашей политике конфиденциальности